Manually trigger trim of old firewall configs

This is the place to discuss DynFi Manager's generic questions.

Moderator: gregober

Post Reply
myowlit8930
Posts: 2
Joined: 25 Aug 2020, 15:31

Manually trigger trim of old firewall configs

Post by myowlit8930 » 28 Jan 2024, 04:14

Hi there, Greg,

Previously, I was keeping all firewall configs with no time limit, but now I would like to reduce the number retained to 180 days. I followed the directions in the Documentation, Section 18.4. I also ensured all firewalls were set to use the global setting. I even toggled all firewalls it to a different setting and then changed it back to the global setting selection just in case that forced the setting to apply. However, the old firewall configs still exist in my database, and there are about 17k config versions being stored, the same number as when I started.

Is there a manual way to prune these or force the new retention rules to apply? Does this happen on a schedule automatically?

Thanks for your help in advance!
Post Reply